tcam-gigetool

An alternative tool to camera-ip-conf.

Arguments

The following arguments may be required by a command:

IDENTIFIER

Unique identifier of the camera: serial number or MAC address

FILENAME

Filename of firmware file to upload

-h, --help

Show a help message

list

List connected cameras.

--format

Format of the device-specific information that will be printed. The field descriptors must be prepended with a ‘%’.

Default is %m%s%u%i.

M

Name of the camera model

S

Serial number of the camera

U

User defined name, may be empty

I

Current ip

N

Current netmask

G

Current gateway

I

Persistent IP, may be empty

N

Persistent netmask, may be empty

G

Persistent gateway, may be empty

F

Interface name, network interface that was used to reach the camera

D

Yes/No field, stating if dhcp is enabled

S

Yes/No field, stating if static ip settings are enabled

M

MAC address of the camera

R

Yes/No field saying if the camera is reachable for streaming

info IDENTIFIER

Show details of a camera.

Possible identifier would be the camera’s serial number or its MAC address.

set [--ip IP] [--netmask NETMASK] [--gateway GATEWAY] [--mode {dhcp,static,linklocal}] [--name NAME] IDENTIFIER

Permanently set configuration options on the camera

--ip IP

IP address to be set.

--netmask NETMASK

Netmask to be set.

--gateway GATEWAY

Gateway address to be set.

--mode {dhcp,static,linklocal}

IP configuration mode to be set.

--name NAME

Set a user-defined name. This is restricted to 15 characters or less.

rescue --ip IP --netmask NETMASK --gateway GATEWAY IDENTIFIER

Temporarily set IP configuration on the camera.

--ip IP

temporary IP address to be assigned

--netmask NETMASK

temporary netmask to be assigned

--gateway GATEWAY

temporary gateway address to be assigned

upload IDENTIFIER FILENAME

Upload a firmware file to the camera.

batchupload [-n] [-b baseadress] INTERFACE FILENAME

Upload a firmware file to all cameras connected to a network interface

-n, --noconfigure

do not auto-configure IP addresses before upload

-b BASEADDRESS, --baseaddress BASEADDRESS

lowest IP address to use for auto-configuration (default=x.x.x.10)